(2 of 5)
Enlarge

  • There are no alternate images available for this product.
 

Klenedraw W-4177

KLENEDRAW W-4177 is a synthetic, VOC-free product, that does not contain petroleum oil, formulated to lubricate a wide variety of metal forming operations. It absorbs on metal surfaces forming a high strength lubricating film. KLENEDRAW W-4177 is effective for multi-stage forming, drawing, deep drawing, roll forming and tube bending applications. When mixed with water at 6:1 or greater, it leaves a minimal residue on metal surfaces after drying.

Usage

KLENEDRAW W-4177 should be used as a straight concentrate, or at dilutions up to 20:1 with tap water. It can be applied in minimal amounts by using Jet-Set airless spray, drip, roller coater or similar methods. KLENEDRAW W-4177 is used on ferrous metals, stainless steel, zinc coated metal, and aluminum. It is typically used on material up to 0.100 (2.5 mm) thick. KLENEDRAW W-4177, run at 4:1, will provide rust protection to ferrous parts stored inside for over 90 days. It can be cleaned with warm water or a weak solution of alkaline cleaner such as TOWERKLENE 42-A run at a 2% 5% concentration.

Benefits

  • Has no VOC
  • Does not contain chlorine, sulfur of phosphorus
  • Exellent rust protection for inside storage
  • Cleans easily in low temperature water based solutions
  • safe to weld through without cleaning
  • mixes easily with water

Documents

Product Technical Data Sheets

Klenedraw W-4177 Klenedraw W-4177